Dome Camera Installation Manual Weatherproof and Indoor versions www. Contents Introduction. Menu System Manual. Page 4 of 1. THE DENNARD TYPE DOME CAMERA. The Dennard Dome Camera is a precision unit, offering a wide. The Dedicated Micros Camera has a number of features which can be selected by the System. Supervisor when the dome is installed. Any of these can be.
|Published (Last):||8 October 2006|
|PDF File Size:||20.49 Mb|
|ePub File Size:||8.86 Mb|
|Price:||Free* [*Free Regsitration Required]|
Also, do I need to terminate the power and control twisted pairs that are also in the pigtail with the coax? Check the dome address switches are correctly set for the controller being used. Already have an account? Ensure the safety bond is fitted.
Mounting Configurations – Indoor Note: OK, I have completely refurbished the dome housings and finally got around to testing the setup but I cannot seem to get any activity from the cameras. For this application, Dedicated Micros offer an optional corner bracket, DM to adapt the standard wall bracket.
Dennard Dedicated Micros 2060 D PTZ Dome Camera CCTV
Camera Version To verify the version of camera supported by the dome software; 1. Page drnnard Secure the mounting disc with 4 x supplied off M6 socket button head fixings D. Dedicated Micros Dennard P.
I did get a Vista DVR too. This lead should be connected to the boxed P. Thread the cable from the bracket throught the cable entry hole in the bottom of the bracket casting, then fit the bracket shown above left. Always support dome with bond prior to mating connector B.
Fit the safety bond bracket E as shown. Create an account or sign in to comment You need to be a member in order to leave a comment Create an account 20600 up for a new account in our community.
EN Limitations of voltage changes, fluctuations and flicker in public lowvoltage supply systems for equipment with rated current up to 16A.
Adjust lift denard gain settings. Snap fit the tile mount bezel E. Weight of dome should be supported by bond ensuring no stress is placed on centre connector B at any time.
Page 32 – Dennad fixed attitude dome camera – ‘zo Use only with the brackets or equipment specified by the manufacturer. Dome Mounting – Weatherproof Dome Lift the dome to the bracket flange ensuring head of screws pass through the keyhole slots. To Frame the image from a Fixed attitude camera; Optimised compatibility with Dedicated Micros controllers. You need to be a member in order to leave a comment.
Solution Reboot the eennard with the joystick self centred.
Dennard Dedicated Micros D PTZ Dome Camera CCTV | eBay
Ensure the safety bond is fitted. Solution Reboot the controller with the joystick self centred.
Always support dome with bond prior to mating connector. Unscrew the 6x fixings securing the outer hemisphere to the casing and remove. Twist once located to secure, dennardd tighten screw heads C to secure the dome enclosure to the mounting disk.
Enter text from picture: Set the individual RS address for the dome on the blue and yellow switches fitted inside the dome housing. Don’t have an account?
Dedicated Mircros Dennard Installation manual |
The mechanism has been designed to fit within the existing housing allowing it to remain compatible with the wide range of Dennard accessories and brackets. From above, clamp to the tile via 2 x off split clamp rings C. Remove and retain the four screws securing the shield to the head and lift off the shield. The desired protocol and the node address for the dome are selected by the two rotary hex switches blue and yellow inside the dome.